শায়ক এর ইংরেজি অর্থ

(noun)

arrow; shaft; dart.

শায়ক এর ইংরেজি অর্থের উদাহরণ

transmissions consisting of three shafts: an input shaft, a countershaft (also called a layshaft) and an output shaft.

connecting intermediate shaft.

Shaft mining or shaft sinking is excavating a vertical or near-vertical tunnel from the top down, where there is initially no access to the bottom.

expansion to extract heat energy from the exhaust and convert it into output shaft power.

An elevator shaft was included in the design because Cooper was confident that a safe passenger elevator would soon be invented.

The shaft was cylindrical.

the shaft has a long curve laterally and anteriorly along two-thirds of the entire shaft.

Shaft horsepower (shp) is the power delivered to a propeller shaft, a turbine shaft, or to an output shaft of an automotive transmission.

A cross section of the hair shaft may be divided roughly.

ossification or formation of the bone starts from three centers; one in the shaft and one in each extremity.

Both these tubercles are found in the proximal part of the shaft.

Most commonly, it is a splined drive shaft installed on a tractor or truck allowing implements with mating fittings.

the shaft, which is the hard filamentous part that extends above the skin surface.

A baluster is a vertical moulded shaft, square, or lathe-turned form found in stairways, parapets, and other architectural features.

The input shaft is connected to the engine.

The flattened lateral region (acromial region) of the shaft has.

An axle or axletree is a central shaft for a rotating wheel or gear.

drivetrain, including clutch, gearbox, prop shaft (for rear-wheel drive vehicles), differential, and final drive shafts.

A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a.

A typical arrow usually consists of a long, stiff, straight shaft with a weighty (and usually sharp and pointed) arrowhead attached to the.

disengages power transmission, especially from a drive shaft (driving shaft) to a driven shaft.

Universal joints let the shaft keep rotating while allowing for changes due to suspension movement, such as shaft length and horizontal.

A coupling is a device used to connect two shafts together at their ends for the purpose of transmitting power.