Noun:

রাং-ঝালাই,

desoldering's Usage Examples:

electronics, desoldering is the removal of solder and components from a circuit board for troubleshooting, repair, replacement, and salvage.

destroy the chip and its content because of the heat required during desoldering.

an electronic printed circuit board (PCB) assembly, usually involving desoldering and re-soldering of surface-mounted electronic components (SMD).

prior to resoldering — desoldering braids (or wicks) or vacuum desoldering equipment (solder suckers) can be used.

pickup tool, and a soldering head; a desoldering station will have a desoldering head with vacuum pump for desoldering through-hole components, and a soldering.

tools for soldering are: contact soldering irons; desoldering tweezers or SMD hot tweezers; desoldering gun; hot air gun; infrared heater.

infrared lamp, or (unconventionally) by soldering individual joints with a desoldering hot air pencil.

mechanical removal of the cover using a milling machine, saw blade or by desoldering and cutting.

4 °F) ChipQuik desoldering alloy.

widely used in the electronics industry as a method of soldering and desoldering components onto circuit boards.

melting point, close to that of the material itself, to prevent the joint desoldering during firing in the enameling process.

This may require desoldering the dead battery and soldering the replacement in place.

electronic devices while simultaneously heating them, for soldering or desoldering.

This is easily repairable by desoldering the tuner shield and re-flowing new solder to each connection inside.

Without developed skill, when manually soldering or desoldering a component, it is easy to accidentally reflow the solder of an adjacent.

conductive part of the pin, slicing the PCB traces, or on some cards, desoldering surface mount resistors.

extremely difficult, technical, and expensive, since it may require desoldering of integrated circuit chips from the circuit board of the device they.

limited reuse may be possible, more than a few cycles of soldering and desoldering are likely to render both the components and the board unusable.

The unit does not have enough power for effective desoldering of many board- and chassis-mounted components.