Noun:

নিরাপত্তা ফ্যাক্টর,

factor of safety's Usage Examples:

In engineering, a factor of safety (FoS), also known as (and used interchangeably with) safety factor (SF), expresses how much stronger a system is than.

allowable bearing capacity is the ultimate bearing capacity divided by a factor of safety.

UTEXAS finds the factor of safety for the slope and the critical failure surface.

catastrophic, such as a crane dropping its load or collapsing entirely, a factor of safety is necessary.

that method, in a sense, a separate factor of safety has been applied over and above the design factor of safety applied to a particular design that uses.

SVSLOPE finds the factor of safety or the probability of failure for the slope.

For example, to achieve a factor of safety of 4, the allowable stress in an AISI.

the factor of safety.

The method has been shown to produce factor of safety values within a few percent of the "correct" values.

The factor of safety for.

Overengineering is often done to increase a factor of safety, add functionality, or overcome perceived design flaws that most users.

Typical duct round plate factor of safety (traditional factor of safety) should be 1.

2}}} is multiplied by a factor of safety to obtain a lower value of the offset yield point.

engineering context, the precautionary principle manifests itself as the factor of safety, discussed in detail in the monograph of Elishakoff.

decided by a factor of safety equal to the ratio of shear strength to the equilibrium stresses along the failure surface.

A factor of safety greater than.

The factor of safety for a specific failure surface is computed as the forces driving failure.

) Response time Reusability Robustness Safety or factor of safety Scalability (horizontal, vertical) Security (cyber and physical) Software.

When used to analyse seismic slope stability it can provide the factor of safety against failure for a given earthquake load, i.

As highway design incorporate a significant factor of safety, drivers can travel faster than design speed without difficulty when.

If one adds a factor of safety of 5 and re-calculates the radius with the maximum stress equal to.

factor of safety is about 30 percent lower.

Because a factor of safety of 1.

Synonyms:

safety factor; ratio;

Antonyms:

undock; break; irrelevance; unpointedness; Phanerogamae;