সহ্য করার ক্ষমতা একটি ইউনিট এক মিলিয়ন ohms তা থেকে সমান

Noun:

রোধের একক,

megohms শব্দের বাংলা অর্থ এর উদাহরণ:

ক্ষেত্রে এটিকে ব্যবহার করা হয় ওহমের সূত্র দ্বারা যা ইলেক্ট্রোমটিভ বল এবং রোধের একক হতে পাওয়া যায়(ভোল্ট এবং ওহম, এই দুটি সহজেই উৎপাদন করা যায় ।

megohms's Usage Examples:

Acceptable insulator resistance values are typically 1 to 10 megohms, depending on the standards referenced.

In the case of transistor current sources, impedance of a few megohms (at low frequencies) is typical.

compensated probe for modest frequencies that presents a load of about 10 megohms shunted by 12 pF.

, [[Purified water#Electrical Conductivity|18 megohms/cm], Resistivity / Conductivity Measurement of Purified Water.

passed through a grid-to-cathode resistor, usually in the range of 1 to 10 megohms, making the grid potential around one volt negative relative to the cathode.

Amplified voltmeters often have an input resistance of 1, 10, or 20 megohms which is independent of the range selected.

the so-called "Wee Megger" (voltage up to 500 V and resistance up to 20 megohms), but there were larger devices like the "Major Megger", "Meg" or "Megger.

This is often either one or ten megohms; the standardization of the input resistance allows the use of external.

An insulation test set; in this pattern, a hand-cranked generator provides the high voltage and the scale is directly calibrated in megohms.

Values ranged from fractions of an ohm to 22 megohms.

The tuning ratio can be very large – the high resistance limit is in the megohms range for symmetrical pinch-off conditions.

commonly found inside a flyback transformer is valued in the hundreds of megohms range, and can therefore not be measured with the common technician's multimeter.

Ultra-pure water could achieve 18 megohms or more.

boundaries, which results in its electrical resistance dropping from several megohms down to a few hundred ohms.

micropipettes, with a tip diameter of < 1 micrometre, and a resistance of several megohms.

In the case of transistor current sources, impedances of a few megohms (at low frequencies) are typical.

occur at audio frequency so the diaphragm requires a high resistance (megohms) to slow the movement of charge for a practical speaker.

while the corresponding figures for a typical screen grid valve were 1 megohms and 0.

output impedance matched the high input impedance (typically about 10 megohms) of the vacuum tube input stage well.

very large impedance of piezoelectric microphones which are measured in megohms.

megohms's Meaning':

a unit of resistance equal to one million ohms