microprogram's Usage Examples:

microcode in a particular processor implementation is sometimes called a microprogram.

A microassembler is a computer program that helps prepare a microprogram, called firmware, to control the low level operation of a computer in much the.

The algorithm for the microprogram control.

sequencer or microsequencer generates the addresses used to step through the microprogram of a control store.

The memory address register is half of a minimal interface between a microprogram and computer storage; the other half is a memory data register.

store or microprogram in many early computers.

A logically equivalent transistor matrix is still used as the control store or microprogram or 'decode.

control store is the part of a CPU's control unit that stores the CPU's microprogram.

MICROMs were supported, but usually two or three could hold the needed microprogram for a processor.

Speed Select Am29111 Microprogram Sequencer Controller - For microprogram memory Am29112 High-performance 8-bit slice Microprogram Sequencer Am29114 Real-time.

The memory data register is half of a minimal interface between a microprogram and computer storage; the other half is a memory address register (MAR).

The processor had external microprogram control, that is, in addition to the CPU, a separate ROM was required.

designed as a microprogram run by a microsequencer.

A microprogram is much like a player-piano roll.

Each table entry of the microprogram commands the.

SDCC LLVM The Small-C compiler MPG, the "machine-independent efficient microprogram generator" retdec ("Retargetable Decompiler") is an open source retargetable.

microprogram control so that timing could be optimized.

A microsequencer, based around the Am2910, directed the control flow through the microprogram.

To facilitate this improvement, IBM used the concept of a microprogram (often called "microcode"), which still sees widespread usage in modern.

The IBM System/360 Model 30 could be ordered with a 1401 compatibility microprogram feature.

It has 16 32-bit registers, and uses a microprogram to define an instruction set of 154 instructions.