Noun:

কাষ্ঠের খাঁজ, কাষ্ঠের ছিদ্র,

mortises's Usage Examples:

consists of cutting two mortises into the edges of two planks, a separate rectangular tenon is then inserted in the two mortises.

mortises cut into them and a separate piece of wood is milled into a fitted tenon which is glued into the two mortises.

For cutting larger mortises such.

images of Yaksha and three mortises carved on them.

These pillars may have belonged to the same monument as the lens-shaped mortises because both have the.

It is used for chopping out mortises when timber framing, or making smaller pieces such as gates.

dried and compressed wood, usually beech, which is installed in matching mortises in both members of the joint in a similar fashion to a loose or floating.

They can also cut joinery such as mortises and tenons.

less common is a type where horizontal logs are tenoned into individual mortises in the posts.

The mortises and pegholes to the former arch bracing to the central house frame could.

The use of pegged mortises and tenons in shipbuilding spread westward from the Levantine littoral.

Self-referencing pins allow the cutting of rows of evenly spaced mortises with no need to measure and mark.

grain of the treenail runs perpendicular to the grain of the receiving mortises which adds structural strength.

One of the pins is adjustable, attached to a sliding fence, so that mortises of different widths can be marked.

blade with straight cutting edge and deep, slightly tapered sides to make mortises and similar joints.

Yaksha and 3 mortises carved on them.

These pillars from Bhadas and Hathin might have belonged to the same monument as the lends-shaped mortises on both have.

The spacing between mortises and the width of the mortises is very tight and they also appear to be slightly wider.

In traditional timber frame joinery, mortises and tenons were typically two inches (51 mm) wide and two inches (51 mm).

raised plantation house, with wood frame built of virgin cypress joined by mortises and pinned with wooden pegs.

The tails fit into mortises in the ends of the board that is the front of the item, hiding their ends.

Joists can also be joined by being slipped into mortises after the beams are in place such as a chase mortise (pulley mortise),.

pieces are mortised and the tenon is a separate piece that fits into both mortises.

Synonyms:

mortice; join; bring together;

Antonyms:

deflate; lengthen; inflate; disjoin;