ohmic's Usage Examples:

which obey it are called ohmic materials.

Examples of ohmic components are wires and resistors.

The current–voltage graph of an ohmic device consists of a.

An ohmic contact is a non-rectifying electrical junction: a junction between two conductors that has a linear current–voltage (I-V) curve as with Ohm's.

to consider two types of loss: ohmic loss and ground loss.

When discussed as distinct from ground loss, the term ohmic loss refers to the heat-producing.

Also known as a voltage-dependent resistor (VDR), it has a nonlinear, non-ohmic current–voltage characteristic that is similar to that of a diode.

However some materials do not obey Ohm's law, these are called non-ohmic.

fastening mechanism (thread, bayonet, braces, blind mate) and springs for a low ohmic electric contact while sparing the gold surface, thus allowing very high.

known as a Schottky diode, while the non-rectifying junction is called an ohmic contact.

as a rectifier any more and becomes an ohmic contact.

This can be used for the simultaneous formation of ohmic contacts and diodes, as a diode will form.

rectification, perhaps due to its Schottky barrier being too low, is called an ohmic contact.

CTH can be operated as a pure stellarator, but also has ohmic heating transformer system to drive electrical current in the plasma.

In either case, increasing the amount of wire reduces the ohmic losses.

and n-type regions are typically heavily doped because they are used for ohmic contacts.

Non-rectifying junctions are called ohmic contacts.

make it a potential candidate for applications such as infrared detectors, ohmic contacts, magnetoresistive devices, and thermoelectric devices.

An ohmic plasma is a plasma that is maintained and/or replenished by the heat produced when a plasma current flows through its resistance as in the induced.

The ohmic resistance R Ω {\displaystyle R_{\Omega }} appears in series with the electrode.