preamplifier's Usage Examples:

A preamplifier, also known as a preamp, is an electronic amplifier that converts a weak electrical signal into an output signal strong enough to be noise-tolerant.

The term microphone preamplifier can either refer to the electronic circuitry within a microphone, or to a separate device or circuit that the microphone.

tube to provide two stages of RC-coupled voltage amplification in the preamplifier section; the power amplifier section used a single cathode-biased 6V6.

Bass amps typically consist of a preamplifier, tone controls, a power amplifier and one or more loudspeakers ("drivers").

current-to-voltage preamplifier.

The fact that the CAFM uses two different detection systems (optical for the topography and preamplifier for the current).

introduce acoustic-electric models, where they pioneered the design of the preamplifier-equalizer component.

clearer and are more pronounced when the input signal is sent through a preamplifier prior to being affected.

equalisations, poor components and accessories (including loudspeakers), preamplifiers historically contained extensive and very flexible equalization and.

differences included the use of higher-gain ECC83 valves throughout the preamplifier, and the introduction of a capacitor/resistor filter after the volume.

amplifier companies often sell standalone amplifier units (which contain a preamplifier and power amplifier) for use with one or more separate speaker enclosures.

acoustic-electric guitars are fitted with piezoelectric pickups, requiring a preamplifier incorporated into the guitar body to amplify the signal before it travels.

including stand-alone preamplifier designs, equalization units and mixing consoles.

Their modular "lunchbox" design allows preamplifier, compressor and equalizer.

standalone wood or metal cabinet that contains only the power amplifier (and preamplifier) circuits, requiring the use of a separate speaker cabinet–or it may.

In order to play DVD-Audio, a preamplifier or surround controller with six analog inputs was originally required.

operating on high quality condenser microphones, phantom power, a microphone preamplifier and a recording device all of which are battery powered.

power amplifier 1950 AE-1 preamplifier 1953 A116 power amplifier, C108 preamplifier 1954 MC30 power amplifier, C4 preamplifier 1957 MR55 AM-FM tuner 1960.

Microphones typically need to be connected to a preamplifier before the signal can be recorded or reproduced.

After the microphone, the signal passes down a cable to the microphone preamplifier, which amplifies the microphone signal to line level.

The pickup was wired to a preamplifier and control box which was either mounted to the bottom key guard, clipped.