Noun:

বরদাস্ত করার ইচ্ছা, বরদাস্ত, পরামর্ষ, অবাধ স্বাধীনতা, সহ্যশক্তিতা, সহ্যতা, সহ্য করার স্বভাব, সহ্যের সীমা, সহ্যসীমা, সহ্যশক্তি, সহ্য,

tolerances's Usage Examples:

investigate the effects of tolerances: Design of experiments, formal engineering evaluations, etc.

A good set of engineering tolerances in a specification, by.

resistance and capacitance values and tolerances", "letter and digit code for resistance and capacitance values and tolerances", or "R notation"[citation needed].

metric screw thread—tolerances) is an International Organization for Standardization (ISO) standard for metric screw thread tolerances.

lowland rivers encourage fish species with broad temperature tolerances and greater tolerances to low oxygen levels, and life history and breeding strategies.

as the type of raw material, the form of the raw material, dimensional tolerances, and secondary processing such as finishing.

657 (Hot-rolled steel sections) is an ISO standard that specifies the tolerances for hot-finished circular, square and rectangular structural hollow sections.

long promoted itself as stressing quality with regard to tight machining tolerances, to within one thousandth of an inch (0.

Tolerancing (GD'T) is a system for defining and communicating engineering tolerances.

760 mm is well within tolerances of 762 mm.

At the same time the tolerances were tightened.

Abrasive processes are usually expensive, but capable of tighter tolerances and better surface finish than other machining processes Abrasive machining.

The ABEC scale is an industry accepted standard for the tolerances of a ball bearing.

Because boring is meant to decrease the product tolerances on pre-existing holes, several design considerations apply.

important to consider the tolerances under which a machine may operate.

Engineers will provide the physicists with expected tolerances for the alignment and.

producing work to the required tolerances to achieve a desired fit range from casting, forging and drilling for the widest tolerances through broaching, reaming.

above foliage, fragrance, length of flowering season, and disease or pest tolerances or resistance.

Presentation of dimensions and tolerances ISO 129-1:2018 Technical product documentation (TPD) — Presentation of dimensions and tolerances — Part 1: General principles.

This process is capable of holding quite close tolerances, often to within 0.

Synonyms:

acceptance; unpermissive; toleration; lenience; permissive; sufferance; temperament; overtolerance; indulgence; permissiveness; leniency; disposition;

Antonyms:

ill nature; uncheerfulness; unpermissiveness; unpermissive; permissive;