yield point's Usage Examples:

yield point is the point on a stress-strain curve that indicates the limit of elastic behavior and the beginning of plastic behavior.

ceramics exhibit a yield point.

Plastic flow initiates at the upper yield point and continues at the lower one.

At lower yield point, permanent deformation.

In brittle materials the ultimate tensile strength is close to the yield point, whereas in ductile materials the ultimate tensile strength can be higher.

until the yield point and the deformation is elastic.

Above the yield point, some degree.

Low-carbon steels display yield-point runout where the material has two yield points.

The first yield point (or upper yield point) is higher than the second.

The linear-elastic region is either below the yield point, or if a yield point is not easily identified on the stress–strain plot it is defined.

This produces an observed upper yield point in a stress–strain graph.

Beyond the upper yield point, the pinned dislocation will act as Frank–Read.

viscoelastic material), with a yield point which is determined by the electric field strength.

After the yield point is reached, the fluid shears as.

X bar charts Yield point – In materials science and engineering, the yield point is the point on a stress-strain curve that.

compression members are usually limited by yield point or buckling stresses that are less than the yield point of steel, particularly for those compression.

The material will begin by elongating uniformly until it reaches the yield point, then the material will begin to neck.

The formation of a Lüders band is preceded by a yield point and a drop in the flow stress.

flow stress can be found for any value of strain between and including yield point ( σ y {\displaystyle \sigma _{\text{y}}} ) and excluding fracture ( σ.

If the upper limit of integration up to the yield point is restricted, the energy absorbed per unit volume is known as the modulus.

The foams can be made of any material with a plastic yield point which includes rigid polymers and metals.

expand the bolt then turning the nut down, torquing the bolt to the yield point, testing ultrasonically, or by applying a certain number of degrees of.

material springs back is equal to the yield strain (the strain at the yield point) for the material.

(also referred to as strain hardening) the material is strained past its yield point, e.

the maximum principal strain reaches the strain corresponding to the yield point during a simple tensile test.

Synonyms:

intercept; factor; intersection point; intersection; ingredient; attracter; constituent; attractor; point of intersection; element; component;

Antonyms:

right; front; back; left; unerect;